SHOTBLOCKERS XT PRO

DOWNLOAD INSTALLATION GUIDE PDF

 step1

STEP 1

Wipe skate down to remove any dirt. Place XT PRO on skate with adhesive backing still on to get a visual of where your product with attach.

STEP 2

Wipe skate down with the provided adhesive promoter and allow to dry for 5 minutes.

STEP 3

Peel backing off the PRO and stick on skate. (knife may be required to start the peel) Apply pressure on the product to make sure it is sticking all around the outside.

step4

STEP 4

Your Shotblockers come pre molded for your skate but for final installation and the perfect fit, the XT PRO must be re-heated and formed to your skate.

This requires a heat gun that can be heated to 270 c . Once you peel the 3m backing off stick the product on the skate and start to heat the product moving the heat gun all around the product it will only take 1 minute for the material to be ready to be molded. Apply light pressure with your hand all over the product to ensure a true custom mold. Repeat this process with each part.

step5

STEP 5

For maximum adhesion allow product to cure for 4 hours.  You will then be ready to BLOCK ON!